Re: Remote Power Supply Connection

On May 20, 4:07=A0pm, "Trevor Wilson"
<trevor@[EMAIL PROTECTED]
> wrote:

> **I fully understand the rationale of keeping the power transformer off
th=
e
> amplifier chassis. OTOH, it makes zero sense in using DC connections
betwe=
en
> two chassis, rather than employing some (very cheap) ****elding around
the
> rectifiers and associated wiring. The safety aspect of using DC is a
serio=
us
> one, which most seem to have neglected.

Howsomever, you have 'neglected' the fact that where handling DC might
be "serious", it is not "impossible". Given that it is not impossible,
the "aspect" is to address it in the most practical, safest way
possible. Not to change the problem to fit the easy solution. Yes,
West is the sort that shouldn't wield anything sharper than a rubber
spoon nor deal with voltages greater than that which can be delivered
by a single carbon-zinc AA cell - but that is neither the point nor
your problem either.

Expensive? Perhaps, but not relative or relevant to a Work-of-Art or
Love. Just doodling for a few moments, I have identified ~US$1,000
worth of connectors, cables and relays that would do the job nicely.
That is without any sort of screening other than using HV DC Connector/
cable/relay in the search string, and assuming 9 pins, 2 plugs, 2
strain-relief fittings, 2 sockets, 2 meters/6 feet of ****elded 600VDC-
rated cable, one DP/DT relay. Took less than 5 minutes.

Requires care? Obviously, but that would be the point anyway.

Would I do it? Not hardly. But I am lazy and simple that way, so no
example from which to judge.

After that, get with the program and be helpful, not obfuscatory and
stupid.

Peter Wieck
Melrose Park, PA