Re: OK to use TV coax for microphone?

"Chris Siz" <default@[EMAIL PROTECTED]
> wrote in message
news:Xns9A936FA2EF13F451E7A@[EMAIL PROTECTED]
> I am in the UK and have a 10m length of some cheap TV aerial coax.  It
> came from a discount store as a TV coax extension cable.  I measure the
> cable diameter as 4.8mm.
>
> (1) Is it ok to use this sort of coax for a microphone?  I don't want
> an impaired audio signal.  The length I need to use is 3 to 4 metres.
>
> (2) Is it ok for UHF TV or is it actually quite low grade coax and
> prone to interference or mess up the aerial signal?
>

Yes, it's OK to use coax for a mic cable assuming the mic is a single
ended
connection (one wire) with ground. The biggest issue is the cable
capacitance. Depending on the mic's impedance, this capacitance will
attenuate high frequencies. A low impedance mike will work better than a
high impedance mic. The accumulated capacitance in four meters of cable
will
be a couple of hundred pico-farads, probably not a problem.

For UHF TV cables are usually 72 ohms. If your cable is 72 ohms, it's
probably OK. If it is 50 ohms it will still work but may degrade the
picture
quality because of reflections within the cable. Try and see. If the
antenna
is 300 ohms, the cable is not suitable unless matched with a balun or
other
impedance matching device.