Re: Need help in replacing headunit in 2000 Camry XLE
by I. Care <icare@[EMAIL PROTECTED]
>
Mar 31, 2008 at 11:49 AM
In article <ZqWdndwZ7oKUuGzanZ2dnUVZ_quhnZ2d@[EMAIL PROTECTED]
>,
noreplay@[EMAIL PROTECTED]
says...
> The 2000 Camry XLE has the premium JBL sound system with a separate amp.
The
> existing Camry radio/6 CD changer went south and I'm replacing it with a
new
> head unit. So I have questions:
>
> 1 Is the amp located behind the glove compartment for the 2000 Camry
XLE?
>
> 2 Where can I get pinout and interconnection diagram information for
the
> XLE? I might just ended up tracing the wires one by one, but if
information
> is available, I would appreciate it.
>
> 3 The new headunit has preamp outputs for both the front and back
> speakers. Is it better to use the existing JBL amp or use the integrated
amp
> on the headunit? Ok, I could try it both ways and found out, assume I
get
> this far.
>
> I've Googled and found very little information on the XLE relative
> switching the JBL sound system to a conventional headunit so thank you
in
> advance for any instructions or advice.
>
>
>
A good source of information can be found a www.crutchfield.com.
http://tinyurl.com/38pxed
This is a PDF file and shows wire colors etc. Apparently Crutchfield
sells wiring adapters to make your installation easier also.
--
I. Care
Address fake until the SPAM goes away ;-}