by Lee <Lee.359yxh@[EMAIL PROTECTED]
>
Feb 24, 2008 at 07:52 AM
boardjunkie;2276775 Wrote:
> I have one of these [ ... ] I can get it to power up, but cannot
> identify which wire is for memory and which is the power ..
If you've managed to get it powered up, and if I recall correctly there
are only 4 wires (Accs, BATT, rem and ground) then set a preset, then
remove one of the two wires you're using for power for a few seconds,
the repower the unit and see if you've lost the preset -- if not, the
one that remained powered is the Battery contant.
Here's the manual for that unit (free at kenwoodusa.com)
http://tinyurl.com/2782wk
greetings
--
Lee
------------------------------------------------------------------------
View thread: http://stage.caraudioforum.com/vb/showthread.php?t=296837
CarAudioForum.com - Usenet Gateway w/over TWO million posts online!
