Re: Console recommendations:

Rupert wrote:

> If the PSU's were RPS-7's, those are flakey units. The regulators tend
> to fail on most, likely due to overheating from either not enough heat
> sink surface area or bad thermal coupling to the heat sink. The desks
> that they drive don't draw that much juice, so it has to be a basic
> design issue. You can use the RPS-11 instead which is beefier, though
> overkill for the smaller desks. They're able to supply much more
> current then the GL2200/GL3300 as they're for the large frame
> GL4000/4800. You have to swap the plug though as they used a different
> connector for the larger desks.

Maybe there is a job at A&H for me after all.

Getting stuff like that right can make or break a company.

Graham