On 27 Apr., 22:33, "Dale Craft" <dcr...@[EMAIL PROTECTED]
> wrote:
> using a Mackie CFX mixer that only has two monitor sends. Since we are
using
> the internal effects on the mixer, we are not using the EFX sends. The
> manual says not to use the EFX send as a monitor send because it's post
> fader.
>
> But we need another monitor mix, so what problems will I have if I try
to
> use the EFX send as another monitor feed? Are there any other
inexpensive
> alternatives. Not ready to buy another board yet.
>
> Thanks,
> Dale
In some desperate cases I've been using this. If you can imagine
something that is not going to be changed (leve wise) during the show,
this might work. I've done this with FX16- we needed mon. line for
keys, and he actually wanted nothing but keys in there, so we took
PostFade AUX with just keys in there. As there was no need to operate
with levels for the PA mix, this worked. It might work nearly in every
setup where you deal with one band only and can have good soundcheck.
Regarding to modify circuitry inside the CFX, this can't be very
complicated, just ask for diagram from local service center.
Einars
|
