by Philippe LEMAIRE <phdl@[EMAIL PROTECTED]
(remove oldies)>
Apr 27, 2008 at 10:11 AM
Bob Cain said...
> Philippe Lemaire wrote:
> > Bob Cain said...
> >> Julian wrote:
> >>> On Sun, 13 Apr 2008 00:03:15 -0700, Bob Cain
> >>> <arcane@[EMAIL PROTECTED]
> wrote:
> >>>
> >>>> Silver epoxy might work. Can you take some pics and post them
somewhere so we
> >>>> can have a look?
> >>> What's silver epoxy and where do you get it?
> >> Radio Shack used to carry it. I've also found it online with Google.
> >
> > I have some :-) !
> > But about 20 years old...
> > Still at least pasty : ELECOLIT 340
> > Electrically Conducting Paint
> >
> >
> >>> What do you think from the photos, Bob? That ribbon probably comes
> >>> out and could be replaced if one can get the part.
> >
> > It seems the whole head : laser/writing head IS ONE part :- ( !
> >
> >> That would certainly be preferable if the part can be obtained.
> >>
> >>
> >> Bob
> >>
> >
> >
> > Philippe who thanks everyone
>
> What I've been using is Circuit Works Conductive Pen CW2200STP and
Overcoat Pen
> CW3300C. This stuff has no significant strength in and of itself and
the parts
> to be connected should be otherwise secured with respect to each other.
>
> I use it mainly to do the Linkwitz modification to electret microphone
capsules.
> I've done dozens successfully with no subsequent failure.
>
>
> Bob
>
Thanks for the info !
I also have some http://www.2spi.com/catalog/spec_prep/spinstr.html
Difficult to choose
Philippe
