John in detroit said...
> Philippe Lemaire wrote:
>
> > I did open :-( !
> >
> >
> > Both wires are broken although a plastic layer is still intact...
> > The other is at right angle of it !
> >
> > Any suggestion as to let the current flow again ?
> >
> > Silver paint ?
> >
> >
> > Philippe
>
> Alas, no suggestions... It has been a few years since I took a look
> inside a Deck (Easier to look into) and even more since I messed with a
> ****table (I did not fully open it, worked "****p in a bottle" style)
>
> Thus, Though I recall what I had to do... The finer points are lost.
>
> I would say to inspect to insure they are truly broken than do what you
> got to do. You may be able to use very fine magnet wire to bridge a
> gap.You may also need to "Anchor" the headin some way. Again, not much
> in the way of suggestions, A thing strip of flexible plastic may work
> for that.. Glued to the top of the head and to the carrier.
>
> However I do not know.. Think of this as a suggestion for investigation.
>
> If you succeed... let us know what it took,, Photos please.
>
Photos before acting were provided...
http://home.scarlet.be/phl/MZ-N1_MD.JPG
Did they show up ?
Philippe
|
